a) Type of insulation in accordance with EN 61010-1 ................................................................. double
b) Measurement category in accordance with EN 61010-1 .................................................... III 600 V
c) Ingress protection in accordance with EN 60529 ...................................................................... IP42
d) Frequency range .............................................................................................................10...70 Hz
e) Nominal phase-to-phase voltage range:
▪
.................................................................................................................... 160...690 V AC
▪
...................................................................................................................... 35...690 V AC
f)
Maximum phase-to-phase working voltage ....................................................................... 760 V AC
g) Measurement current (per each phase) .............................................................................. <3.5 mA
h) Working temperature ....................................................................................................... -10...45ºC
i)
Storage temperature ...................................................................................................... -20...+60ºC
Acceptable working humidity ............................................................................................. 20...80%
j)
k) Tester power supply ................................................................ from the tested electrical installation
l)
Dimensions .......................................................................................................... 130 x 72 x 31 mm
m) Mass of the tester (with leads) ............................................................................................ ca 340 g
The device does not have the character of a standard and therefore is not subject to
calibration. The proper form of control for this type of instrument is checking.
The standard set of equipment supplied by the manufacturer includes:
1,2 m test leads integrated with the tester (red, black and yellow) – 3 pcs,
crocodile clip black K01,
probe with banana plug (red, black and yellow) – 3 pcs,
user manual.
The current list of accessories can be found on the manufacturer's website.
The manufacturer of the device and provider of guarantee and post-guarantee service:
NOTE!
Service repairs must be performed only by the manufacturer.
10
6
Technical data
7
Standard accessories
8
Manufacturer
SONEL S.A.
Wokulskiego 11
58-100 Świdnica
Poland
tel. +48 74 858 38 60
fax +48 74 858 38 09
E-mail:
export@sonel.pl
Web page:
TKF-12 ● TKF-12L – USER MANUAL
www.sonel.pl