Residual Risks; Operation; Tighten Cover On The Polishing Disc; Switching On And Off - ULTIMATE SPEED UPM 120 B3 Traducción Del Manual De Instrucciones Original

• This device is not intended for
use by people with restricted
physical, sensory or mental fac-
ulties or those who do not have
sufficient experience or knowl-
edge of it.
• Do not allow yourself to be
lulled into a false feeling of se-
curity and do not disregard the
safety rules for power tools,
even if you are familiar with the
power tool after using it many
times. Acting carelessly can result in
serious injuries within fractions of a sec-
ond.

Residual risks

Even if properly operating and handling
this electric tool, some residual risks will
remain. Due to its construction and build,
this electric tool may present the following
hazards:
a) Lung damage, if suitable respiratory
protection is not worn;
b) Ear damage if working without ear pro-
tection.
c) Eye damage if no suitable eye protec-
tion is worn.
d) Damage to your health caused by
swinging your hands and arms when
operating the appliance for longer pe-
riods of time or if the unit is not held or
maintained properly.
Warning! During operation, this
electric tool generates an electro-
magnetic field which, under certain
circumstances, may impair the
functionality of active or passive
medical implants. To reduce the risk
of serious or lethal injuries, we rec-
ommend that persons with medical
implants consult their doctor and
the manufacturer of their medical
implant before operating the ma-
chine.

Operation

Caution! Risk of injury!
- Always remove the mains plug
before working on the tool.
The mains cable is to run over the
user's shoulder during the use of the
polishing machine to avoid contact
with the polished surface. This is to
prevent scratches from the mains
cable.
Tighten cover on the
polishing disc
1. Align the polishing disc (3) upwards.
2. Using both hands, grab hold of a
towelling cover (5) or a synthetic fur
cover (4) and expand the elastic band
outwards.
3. Put the cover (4/5) on a part of the
polishing disc (3) over the edge of the
polishing disc. Pull the cover around
the edge.
4. Fit the cover (4/5) in centrally and
tightly around the polishing disc (3).

Switching on and off

Make sure that the power supply
voltage matches the voltage rating
indicated on the device's type
plate.
Connect the machine to the power
supply.
GB IE
19