Basic Functions - YONO Cinta métrica láser Guía De Usuario

Basic Functions

In the Off State
Press and hold the button for 2 seconds to turn it on
Single Measurement
Short press the button to start a single measurement
Continuous Measurement
Press and hold the button for 2 seconds to start continuous measurement
Multi-function Measurement
Just press the button, you can switch distance, area, volume and Pythagorean
measurements.
m m
2 3
m m
Benchmark Setting
Short press the button to enter the front and rear reference
setting mode.
1. Set the machine front
end as the starting
reference.
Notice:
In the future reference measurement, the measured data displayed includes 8 cm of the
body size.
m
m
2. Set the machine
backend as the starting
reference.
10
Unit Switching
Press and hold the button for 2 seconds to switch to another unit of measure.
m
m in
Shutdown
Press and hold 2 seconds to turn off.
Correction Function Setting
Step 1
When the product is in the off state, if you press and hold the
the calibration mode can be performed and the screen displays (boot) at this moment.
Step 2
Precision adjustment setting:
In calibration mode, again press and hold the
precision adjustment setting. The screen will display the present precision setting (such
as CAL.0). The precision for the machine can be adjusted from -7 till +7 mm, and you
just short press the button to get it.
Step 3
Mute button setting: in the previous mode press and hold the
enter the button mute setting mode. Then turn on/off the button sound by short
pressing the button.
ft
Clear Data
Short press the button to clear the data.
button for 5 seconds,
button for 2 seconds to enter the
for 2 seconds, to
the sound is on
the sound is off
11