1byone O00QH-0507 Manual De Instrucciones página 4

These are referred to as Sound, Flash, and
EN
Sound+ Flash mode.
DE
To select , switch the Sound and flash switch to
one of the following position:
FR
ES Sound only mode
IT
Sound +Flash mode.
B. Selecting the ringtone:
There are 36 programmable ringtones to
choose from.
Press the Ringtone selector button
change the ringtone.
Stop pressing this button when you reach the
desired ringtone.
C. Adjusting ringtone volume:
Press the Volume button
volume is set. There are 3 volume levels for
selection.
D. Pairing additional PIR sensors to the alarm
doorbell system:
Flash only mode
to
VOL
until the desired
1/2/3
- 05 -
Up to 5 PIR sensors can be paired with one
receiver, pair additional PIR sensors using the same
pairing process as described below:
The following pairing instruction is relevant to PIR
sensor SKU O00QH-0508
After power the PIR sensor, press the Paring button
on the side of the receiver. Next trigger the PIR
sensor. If pairing is successful, the receiver should
ring. It normally takes about 30 seconds for the PIR
sensor and receiver to pair. If there is no pairing
within 30 seconds, the receiver will automatically
exit pairing mode. Please try pairing again.
E. Re-pairing Function:
If a receiver ring but nothing trigger the PIR
sensor, or when you wish wipe some PIR sensor
from a receiver, or when the PIR sensor
interferes with another receiver, it may be
necessary to wipe the current pairings and pair
again:
For wiping the PIR sensors, please cut down the
power supply of the receiver and PIR sensor,
remove the batteries from the PIR sensor and
unplug the receiver.
Reattach the receiver and push button to power
- 06 -
EN
DE
FR
ES
IT