Signal Range; Frequently Asked Questions; Technical Data - Marmitek PH7208 X-10 Modo De Empleo

USING THE PH7208
To prevent false alarms the technology used waits for 5 command cycles (20 seconds)
before the siren is activated. After the siren has been activated it emits a piercing two-
tone signal for 4 minutes. After this the siren switches off automatically (or before this
if the alarm is deactivated).
CAUTION: When using Marmitek alarm systems these sirens always operate during an
alarm, regardless of whether the silent alarm function has or has not been switched on!

SIGNAL RANGE

The Marmitek X-10 System is based on power line communication. The range of the
Marmitek X-10 signals very much depends on the local circumstances. On average the
range is a cable length of 80 meters.

FREQUENTLY ASKED QUESTIONS

Does the PH7208 also work during a power failure?
No, the PH7208 receives it power from the 230V mains. The communications from the
station to the PH7208 is also via the 230V wiring.
Do you have any questions that have not been answered above? Then please
refer to www.marmitek.com.

TECHNICAL DATA

Power supply:
Siren:
Sound pressure:
Signal sensitivity:
Input impedance:
Responds to X-10 key codes:
Ambient temperature:
Fixing:
Dimensions:
4
230V AC 50 Hz
Piëzo, 4-fold
110dB(A)
15 mVpp min, 50mVpp max at 120 kHz
> 55 Ohm (P-N) at 120 kHz
Automatically after 5x All Lights On/All Units off
command or 5x ON OFF
-10°C to +50°C (operation)
-20°C to +70°C (storage)
Wall mounted
129x81x50mm
© MARMITEK