Cleaning, Maintenance And Ordering Of Spare Parts - Parkside P-AS 3,6 Li Manual De Instrucciones

Anleitung_P_AS_3_6_Li_4513417:_
GB
8.5 Handle adjustment (Fig. 1.2/Item 3)
The screwdriver can be locked into 2 different
angle settings. To do so, press the locking
button (3) and move the screwdriver into the
desired position. Then release the locking
button (3).
Caution:
Before you switch on the screwdriver, make
sure that it is correctly locked in the required
angle position.
8.6 Battery capacity indicator
(Fig. 4/Item. 5)
Press the button for the battery capacity
indicator (6). The battery capacity indicator (5)
indicates the charge state of the battery on 3
coloured LEDs.
All LEDs are lit:
The battery is fully charged.
The yellow and red LED illuminate:
The battery has an adequate remaining charge.
Red LED:
The battery is discharged, it requires charging.
8.7 Changing the tool (Fig. 5)
Caution:
Adjust the switch (10) to the middle setting
when carrying out work on the cordless
screwdriver (Changing the tool; Maintenance;
etc.).
Pull back and hold the locking sleeve (14).
Insert the bit (a) into the bit chuck (1) and let
go of the locking sleeve (14)
Check that it is properly secure by pulling
the tool.
For removal of bits (a), pull back the locking
sleeve (14) and hold it firmly.
Remove the bit (a) and let go of the locking
sleeve.
48
16.04.2009 8:29 Uhr Seite 48
8.8 Torque Setting (Fig. 1/Item 13)
The cordless screwdriver is fitted with a
mechanical torque selector.
The torque for each particular screw size is
adjustable at the torque selector (13). The
required torque is dependent upon several
factors:
the type and hardness of the material to be
worked with.
the type and length of the screws used.
the physical burden placed on the screw
connection.
When the torque is reached, this is indicated by
the clutch being released.
Caution:
Only adjust the torque when the appliance is at
a standstill.
8.9 Screws
It is advisable to use self-centering screws (e.g.
Torx, Philips head screws) as these will enable
you to work safely and reliably. Always make
sure that the bit used is of the same size and
shape as the screw.
8.10 Screwdriver overloaded
If the screwdriver is overloaded, the automatic
safety switch turns the device off. After a few
seconds the screwdriver can be used again.
9. Cleaning, maintenance and
ordering of spare parts
Caution:
Always pull out the mains power plug before
starting any cleaning work.
9.1 Cleaning
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the appliance with a clean
cloth or blast it with compressed air at low
pressure.
We recommend cleaning the appliance
immediately after every use.