Reseting The Factory Settings - Krups XP6180 Manual De Instrucciones

KR_ESPRESSO_XP6180_NC00023127-03_Mise en page 1 09/03/12 09:50 Page16
English
To start programming, press the "PROGRAM" button (fig. 27). It will illuminate red and the "MANUAL"
button will turn off. The lights above the "POWER", "SINGLE" and "DOUBLE ESPRESSO" buttons
will remain on.
Press the "SINGLE ESPRESSO" button to start (fig. 27). The light above the "DOUBLE ESPRESSO"
button will turn off, and only the "POWER" light, "SINGLE ESPRESSO" light and "PROGRAM" light
will remain on.
Stop the flow at the desired level by pressing the "SINGLE ESPRESSO" button.
2 beeps indicate that the programmed volume is memorized.
NOTE: recommended maximum espresso volume of single cup is 50ml.
The espresso machine is ready to make another espresso
PROG RAM M I NG DOU B LE E S PR E SSO VOLU M E
Fill the water tank with fresh cold water to the maximum line and press the "POWER" button. The
light behind the "POWER" button will illuminate green and start flashing to indicate that your machine
is on and heating up. When the green light behind the "POWER" button will stop flashing and turns
to a constant red light, this indicates that the espresso machine is heated and ready to use.
Tip: We recommend using the double cup filter when using the programmed double espresso operation.
With the measuring spoon, add one level spoon of ground coffee per cup of espresso. (fig. 10).
Using the tamper included with the espresso machine, tamp the coffee grounds into the filter holder
(fig. 11). For a proper tamp place the filter holder on a flat surface then press the bottom of the tamper
onto the coffee grounds with firm pressure to pack it into the filter holder. Twist the tamper 90 degrees
to polish the grounds. This seals the surface of the coffee cake.
Remove any excess espresso grounds from the edge of the filter (fig. 13).
Insert the filter holder and turn the handle to the right to firmly secure it into the group head (fig. 8).
Put one or two cups under the filter holder as desired (fig. 14-15).
To start programming, press the "PROGRAM" button (fig. 27). It will illuminate red and the "MANUAL"
button will turn off. The lights above the "POWER", "SINGLE" and "DOUBLE ESPRESSO" buttons
will remain on.
Press the "DOUBLE ESPRESSO" button to start (fig. 27). The light above the "SINGLE ESPRESSO"
button will turn off, and only the "POWER" light, "DOUBLE ESPRESSO" light and "PROGRAM" light
will remain on.
Stop the flow at the desired level by pressing the "DOUBLE ESPRESSO" button.
2 beeps indicate that the programmed volume is memorized.
NOTE: recommended maximum espresso volume of double cup is 100ml.
The espresso machine is ready to make another espresso.

RESETING THE FACTORY SETTINGS

To revert back to the original factory settings:
IMPORTANT: Although the espresso machine is plugged in ensure that the actual espresso machine power
is "OFF". Therefore, no lights will be illuminated on the espresso machine control panel.
Press and hold down the "MANUAL" button. While still holding down the manual button briefly press
the "POWER" button and then release the "MANUAL" button.
When you hear the 4 beeps and the power light will flash and the espresso machine will have returned
to the original factory settings and the next time the single or double espresso functions are used the
espresso pours will be 1 ounce and 2 ounces.
16