Dragon Touch DF01 Manual Del Usuario página 5

READY TO FLY
Note:
① Make sure the propellers and propeller protective covers are correctly installed
and tightened.
② Before flying, please pair the drone with the remote control and calibrate the
drone and the remote control.
1. HOW TO PAIR YOUR DRONE WITH THE REMOTE CONTROL
① Turn on the fuselage power switch and place the drone on a level surface.
② Turn on the remote control power switch.
③ Place the drone on a level surface. Push the left joystick upwards to the top,
then pull downwards as far as possible. At this time, you will hear two beeps
from the remote control, and the indicator light will change from quick flashing
to constant on, indicating that pairing is successful.
①
2. HOW TO CALIBRATE AND TAKE OFF
① Place the drone on a level surface. Push the left and right joysticks as shown
above simultaneously for 2-3 seconds. The drone lights will flash fast and
turn to constant 'on' in 2-3 seconds, indicating the calibration is successful.
5
② ③
② To take off, the first method is to press the one-key takeoff button. The second
method is to operate the two joysticks at the same time as shown above for
2-3 seconds to unlock the drone, then slowly push the left joystick upwards.
3. HOW TO LAND
Method 1: Slowly push the left joystick down until the drone descends slowly to
the ground. Hold the left joystick at the lowest position for 2 seconds,
the motor will stop and the drone is landed successfully.
Method 2: When the drone is flying, press the one-key takeoff button again and
the drone will land slowly.
6