Publicidad
Idiomas disponibles
Idiomas disponibles
Before you begin
• Read all instructions before set up.
• Select a level site clear of rocks, branches, and other hard or
sharp objects, to install your tent.
WARNING: Keep clear of overhead power lines.
• Do not set up your tent under trees because of potential lightning
strikes or falling tree limbs in inclement weather.
• Secure with all stakes and guylines provided to prevent property
damage or personal injury.
• For best results in windy conditions, position narrow end of tent
into the wind.
• Enlist the help of at least one other person to assist you when it
is time to assemble the tent.
Pole Descriptions
Description
no.
1
Awning Pole, fiberglass, black, thick
Steel Roof Pole, steel, gray
2
3
Steel Leg Pole, steel, gray
1
Layout & Positioning
of Tent and Poles
• Layout and position the tent with both doors facing desired
directions. (Fig. 1)
• Stake down tent corners by driving the stakes into the loops
attached at the bottom of the tent. (Fig. 2)
• Keep the floor taut.
• Assemble all poles by unfolding and interlocking the shock-
corded pole sections.
• Insert one end of roof pole to the 8-in-1 pole hub at the center,
and the other end will be inserted into to the pole connector at
tent corner at step 2. (Fig. 3)
Roof
Pole
Tent
Stake
Fig. 2
TenT SeTUP InSTRUCTIOnS
Tent Octagon 98 - Half Rainfly
(The product may look different from yours. It is for illustration purpose only.)
Qty.
Pole
Pole
Repair Kit
Replacement Kit
2
5010000569
5010000568
8
N/A
N/A
8
N/A
N/A
Leg Pole
Roof
Fig. 1
Pole
Pole
Hub
2
Connect Poles to Tent
• Insert roof poles and leg poles into pole connectors. (the
color marking on the leg poles should match the mark on
pole connectors)
• Insert one pin into the end of the leg pole. (Fig. 5 and 6)
• Repeat for all leg poles.
• The tent will raise as the leg poles are all connected with
the tent.
NOTE: The tent door should between the adjacent leg poles
with awning pole connector.
Pole
Connector
Leg
Pole
Pin
3
Attach Tent to Leg Poles
Using Clips
• Attach clips along the edges of tent to leg poles. (Fig. 7)
• Make any adjustments to the tent stakes, if needed.
Fig. 3
Roof Pole
Fig. 4
Leg Pole
Fig. 5
Pole
Fig. 6
(continued on other side)
Awning Pole
Connector
Clip
Fig. 7
Publicidad
