Publicidad
Idiomas disponibles
Idiomas disponibles
EXTERNAL SPEAKER OUTPUT
19
One 2-pin twist-lock powered speaker output, paralleled with 1/4" powered speaker output (20).
1/4" EXTERNAL SPEAKER OUTPUT
20
1/4" powered speaker output, paralleled with 2-pin twist-lock powered output (19).
FOOTSWITCH JACK
21
Plug your Headliner footswitch into this 1/4" jack. The footswitch controls the crunch effect and
the compressor on/off. NOTE: The crunch and compressor buttons MUST be engaged to operate
with the footswitch. The part number for the TNT/Headliner footswitch is 03008010.
EFFECTS LOOP
22
The Send Jack provides a preamp output that may be used to drive slave amplifiers and external ef-
fects processors. The Return Jack provides a power amp input for the last effect in the chain. NOTE:
When using the unit as a slave power amplifier, the Return Jack should be used as the input.
DIRECT INTERFACE (DI)
23
This built-in, balanced Direct Interface is used to send a buffered signal to an external mixer.
DI PRE/POST SWITCH
24
This button toggles the DI output from pre EQ to post EQ.
GROUND LIFT
25
This button is provided to prevent a ground loop that may result in "hum" noise. When depressed
(IN position), Ground Lift is engaged.
Tour Series Headliner Head Block Diagram
A
1
BRIGHT
INPUT
2
PAD
3
4
A
B
HEADLINER FUNCTIONAL BLOCK DIAGRAM
HI PASS
PRE GAIN
CONTOUR
NOTCH
PRE/POST EQ
BALANCED DI
2
1
4
3
GROUND LIFT
SPEAKER OUTPUTS
B
C
CRUNCH CIRCUIT
HI PASS
LO PASS
COMPRESSOR
STEREO HEADPHONE JACK
1
2
POWER AMPLIFIER
6
C
SHELVING EQ
EQ
Graphic EQ
LO
HI
POST GAIN
HEADPHONE AMPLIFIER
Peavey Electronics Corp.
HEADLINER_BLOCK
Title:
Sheet Title:
B
Sheet
D
1
FX SEND
2
FX RETURN
3
4
P. O. Box 2898
Meridian, MS 39301
of
Date:
1
1
2-18-2010_17:02
D
Publicidad
