Publicidad
INSTALLATION INSTRUCTIONS
for In-Line Shower Filter, Model ISH-100/ISH-200/ISH-200c:
Installs on any standard
1. Remove existing showerhead from shower pipe by turning
counterclockwise.
2. Clean any debris that may be present on the threaded pipe.
3. Wrap 3 layers of Te on
around shower pipe threads.
4. Attach Culligan
shower by hand. Screw on the Culligan
Shower Filter until the lter is secure
(approximately three revolutions).
DO NOT OVERTIGHTEN! If your shower arm
is too short, you can remove the cartridge and cap
then screw the lter base into the shower arm.
Once the lter base is in place you can replace
the cartridge and cap.
5. Wrap three layers of Te on
threads on the outlet end of the Culligan
In-Line Shower Filter.
6. Install your showerhead and hand tighten.
7. Check for leaks and tighten as needed. Flush the cartridge for ve
minutes to remove all carbon nes.
CARTRIDGE CHANGE PROCEDURE
for Filter Cartridge, Model WHR-140:
1. Manually unscrew the shower lter cap from
the shower lter base.
2. Grasp white lter cartridge and pull cartridge up
and to the side to remove.
3. Place new lter cartridge into position by pushing
cartridge down into cavity until seated
4. Replace the shower lter cap. Flush cartridge
with water for ve minutes to remove any loose
carbon nes.
" threaded shower pipe
1
/
2
tape (included) tightly
®
In-Line Shower Filter to the
®
tape around the
®
In-Line
®
®
Publicidad
