Whittier Wood Products 134W Swivel Barstool Instrucciones Para Armar página 3

FIG. 4
TO ATTACH THE BACK SPINDLES TO THE
SEAT:
4) Spread glue evenly in the holes in the Seat
(E). Working quickly before glue sets, insert
the groove coded end of each Back Spindle
(FS) into each hole in the seat, as shown in
FIGURE 4.
FIG. 5
TO ATTACH THE BACK REST:
5) Start by applying glue evenly in each spindle
hole in the Back (G). (Apply glue carefully,
as it may drip out before you have put the
back in place). Begin on one side, gently
tapping the back rest onto each spindle
until you have worked your way around to
the opposite side, as shown in FIGURE 5.
Check to see that the back is all the way
down on each spindle before you set the
assembly aside to dry.
FS
G
E
FIG. 6
TO ATTACH THE LEGS TO THE DISC:
6) Place the disc (B), top side down, on your
work surface. (The top side is marked with
indentations for attaching the swivel later).
Spread glue evenly in each leg hole in the
disc, and a thin film of glue around the end
of the turning. Put a Leg (A) in each hole
and tap into place with the rubber mallet, as
shown in FIGURE 6.
AT THIS POINT FINISH THE STOOL
BEFORE PROCEEDING TO STEP 7.
BE SURE TO READ THE ENCLOSED
CC
FIG. 7
TO ATTACH THE RING TO THE LEG
ASSEMBLY:
7) Slip the Ring (CC) over the top of the leg
assembly and down to the ring grooves on
the legs, located approximately 11" above
the floor. Drill a 1/8" pilot hole through the
hole in the ring approximately 5/8" into each
leg. Fasten the ring into place using the
#10 x 1½" Brass Screws (H). See FIGURE 7.
A
FINISHING HINTS.
A
B
H
134W — Page 3