ION FCS Board Mount Guía Rápida De Usuario página 3

3.1 Secure Strap
1. Loop one end of the secure strap through the strap hole of the camera. You may use a pin to help
thread it through the hole.
2. Attach the other half to the secure piece.
3. Clip both ends together after the camera has been secured to the FCS Board Mount.
3.2 Attaching the Fix Screw to your Camera
1. Fit the screw of the Fix Screw to the tripod socket of the camera.
2. Screw the Fix Screw until it is tightened onto the camera.
(The diagram is for illustration purposes, outer appearance of the camera is subject to the model being
connected)
4. Mounting on your Board
To install the camera on the board with the FCS Board Mount, your board should be pre-installed with a
FCS centre fin socket. A matched screw should be supplied with the FCS centre fin socket (both are not
included in the package).
1. Loosen the nut and take out the connection screw from the FCS board mount.
2. Plug the FCS plug into the FCS centre fin socket on your board.
3. Insert the matched screw into the hole of the FCS centre fin socket through the loophole of the
FCS plug and then tighten the screw.
EN-2