Switch Positions - SEVERIN WL 0801 Manual Del Usuario

- in case of any malfunction and,
- during cleaning.
■
This appliance is not intended for use by
any person (including children) with
reduced physical, sensory or mental
capabilities, or lacking experience and
knowledge, unless they have been given
supervision or instruction concerning the
use of the appliance by a person
responsible for their safety.
■
Children should be supervised to ensure
that they do not play with the appliance.
■
Caution: Keep any packaging materials
well away from children, as they are a
potential source of danger e.g. from
suffocation.
■
No responsibility will be accepted if damage
results from improper use, or if these
instructions are not complied with.
■
This appliance is intended for domestic use
only and not for commercial applications.
■
In order to comply with safety regulations
and to avoid hazards, repairs of electrical
appliances must be carried out by qualified
personnel, including the replacement of the
power cord. If repairs are needed, please
send the appliance to one of our customer
service departments. The address can be
found in the appendix to this manual.
Operation

Switch positions

The appliance is equipped with a 4-position
switch allowing for the following settings:
Functions:
0 = Off
1 = Half power / low temperature
2 = Full power / high temperature
❄ = Cool function
Removing and changing the attachments
■
Always switch the appliance off and
allow it to cool down to room
temperature before changing or
removing any attachments.
- To remove an attachment, press and hold
the lock/release button on the housing,
turn the attachment clockwise until the lock
symbols are aligned, and then pull it off.
- To fit an attachment, follow the same steps
in reverse order while applying only light
pressure, making sure the small lock
symbols (or the dash marks) are aligned.
Lock the attachment in place by turning it
anti-clockwise, when the lock symbol on the
housing and the dash mark should be
aligned.
- Without any attachment fitted, the
appliance can be used as a hair dryer.
Round brush
This is useful for giving more volume to the
hair. Position the brush near the roots, and pull
it gently through the hair towards the ends.
Ceramic round brush
The hot air heats up the metal cylinder so that
the heat can work directly on the hair.
This is helpful when shaping the hair so that
the ends curl inwards or outwards.
Styling nozzle
Attaches to the air-outlet opening and helps to
shape the hair while blow-drying.
Use
- The appliance should only be used on hair
that has been dried, and is no more than
slightly damp.
- The round brush is designed for shaping
the hair. To achieve this, the hair should be
divided into single strands (not too thick)
and then spread evenly over the brush,
turning them inwards or outwards as
desired.
- Apply for a few seconds at a time only,
while letting the hot air take effect on the
hair. Let the strands uncurl afterwards.
Hint:
Using the cool-function before unrolling the
strands will give the hair a firmer, longer-
lasting shape.
10