Delete Maximum Values; Set The Overload Warning Value; Proceed As Follows - brennenstuhl PM240S Manual De Instrucciones

q
i
i
q
note: in this mode you have a choice between two overload
warning values. You can set an overload warning value for
the current (A) and an overload warning value for the power
consumption (W).
note: the overload warning value for power consumption
(W) 8 is set by default to 0000 W on delivery.

Proceed as follows:

1. Press the UP button 5 until the OVERLOAD symbol 7
Energiekostenmessgeraet_Content_PM240S_1.indd 49

Delete maximum values

Use the UP button 5 to select one of the two maximum
values (see "Maximum current", "Maximum power con-
sumption").
Keep the SET button 6 pressed for approx. 3 seconds
to reset the maximum value to 0.

Set the overload warning value

appears in the top third of the LCD display 2
note: the wattmeter is programmed so that the over-
load warning value for power consumption (W) 8
automatically flashes first.
Operation
GB 49
09.03.09 12:53