Prior To Operation - DeWalt DC330 Traducido De Las Instrucciones Originales

A wide variety of dedicated saw blades is available
as an option.
WARNING: Always select your saw
blade with great care.
Setting the Bevel Angle (fi g. D)
The adjustable shoe (8) allows cutting of LH and RH
bevel angles up to 45°. The bevel scale has preset
positions at 0°, 15°, 30° and 45°.
• Release the shoe lever (10).
• Slide the shoe (8) toward the saw blade.
• Tilt the shoe and set the desired bevel angle
using the scale.
• Tighten the shoe lever.
Setting the Pendulum Stroke (fi g. A)
The adjustable pendulum stroke guarantees a
perfect cutting stroke for different materials.
• Slide the selector (9) to the desired position
referring to the table below. The selector can be
manipulated during operation.
Pos. Wood
3 Fast cuts
2 Thick workpieces
1 Plywood
Chipboard
0 Thin workpieces
Fine cuts
Setting the Sawdust Blower (fi g. A)
The sawdust blower conducts an adjustable stream
of air to the saw blade to keep the workpiece clear
of sawdust during operation.
• Set the sawdust blower using the lever (3).
– Low For working with metals, when
using coolants and lubricants
and for use with dust
extraction.
– Intermediate For working with wood and
similar materials in low speed.
– High For working with wood and
similar materials in high speed.
Mounting the Plastic Anti-scratch
Shoe Cover (fig. E)
The anti-scratch shoe cover (17) reduces damage to
the surface of (sensitive) workpieces.
• Click the cover onto the shoe as shown.
Mounting and Removing the
Anti-splinter Shoe Insert
(fi g. F1, F2)
The anti-splinter shoe insert (18) which fits close to
the saw blade reduces splintering of the workpiece.
The insert can be mounted both into the shoe and
the shoe cover.
• Hold the insert (18) in the orientation as shown.
• To mount the insert into the shoe (8):
• To mount the insert into the cover (17):
• To remove the anti-splinter shoe insert do the
Dust Extraction (fi g. G)
Metal Plastics
The dust extraction adaptor (22) in combination with
– PVC
the dust extraction shroud (23) helps extracting the
dust from the workpiece surface, when connected
– Fibreglass
to a suitable dust extraction system.
Acrylic
• Place the dust extraction shroud (23) onto the
Aluminium –
Non-ferrous –
• Fit the dust extraction adaptor (22) to the tool as
Sheet metal –
• Connect the hose of a suitable dust extraction

Prior to Operation

• Make sure your battery pack is (fully) charged.
– Slide the edges (19) into the grooves (20).
– Slide the insert back into position against the
shoe.
– Slide the edges (19) behind the ribs (21).
– Push the front end of the insert towards the
cover. The insert snaps into place.
above process in reverse order.
finger guard (5) until it clicks in place.
shown.
system to the adaptor.
WARNING: Inhalation of dust
developed when sawing wood presents
a serious health hazard. Always connect
a dust extraction system designed
in compliance with the applicable
directives regarding dust emission.
Preferably wear a dust mask.
WARNING: Do not use a dust
extraction system without proper spark
protection when sawing metal.
EN GL I SH
41