Mesko MS 8146 Manual Del Usuario página 4

20. Do not use for commercial or medical purposes.
21. It is advisable to brew at the same time every day.
22. The values given by the weight can be misleading when measured after vigorous
exercise, a strict diet or dehydration.
23. People under the age of 18 and older people may only use the weight measurement
option. The indication of the measurement options (amount of water, fat or muscle) can be
confusing for elderly people over 80 and people who are into bodybuilding.
24. If your measurements are abnormal, consult your doctor.
25. The scale will not calculate your body fat unless you are barefoot.
26. To measure body fat accurately, do not bend your legs at the knees, keep your legs /
thighs apart on the measurement plates and stand straight on the scales.
27. The body fat function is not recommended for pregnant women, people on dialysis with
pacemakers and other medical implants, people with fever, swollen legs or other edema.
And also for people who are over-hydrated or dehydrated.
28. Fat percentage may be slightly higher or lower in people with diabetes and other medical
conditions.
29. Women naturally have about 5% more body fat than men.
DESCRIPTION OF THE DEVICE (Fig. A)
1.LCD display
2.Glass platform
FUNCTION KEYS:
▲
- up button
SET - on button/parameter change button
ERROR MESSAGES
Lo- low battery, replace the battery
CHANGING WEIGHT UNITS
You can change the units that the weight is displayed in using the switch found under the scales, next to the battery container or under
the cover of the container. Available units: kilograms (kg) and pounds (lb).
BATTERY REPLACEMENT (Fig. B)
Before use remove the isolating layer from the battery contact plate. Note the polarity.
1.Open the battery cover at the bottom of the scales. Remove the old battery.
2.Insert the new battery by sliding one end of the battery into the contact plate and pressing the other side in. Close the cover.
WEIGHING
STEP 1. Place the scales on a hard and flat surface (avoid carpets and soft surfaces).
STEP 2. Gently step on the scales. Stand on the scales evenly distributing your weight and do not move until your weight reading
shown on the display stops changing and gets blocked.
SETTING MEASUREMENT PARAMETERS (Fig. C)
STEP 1. Place the scales on a hard and flat surface (avoid carpets and soft surfaces).
STEP 2. Press the SET button. An option to set the user code will appear.
▲
STEP 3. Use the and
STEP 4. Press SET to confirm.
Repeat steps 3 to 4 to set the age (2), gender (3), and height (4). After approximately 7 seconds from the last press of the SET button
the scales will switch to the weighing and measuring mode.
WEIGHING WITH MEASUREMENT (Fig. D)
3.Function keys
4.Measurement plates
▼
- down button
Err1kg- maximum load exceeded
▼
buttons to choose a user code (1).
4
Err2% - error