Tripp-Lite T100-001-TST Manual Del Propietário página 4

Operation
Testing Uninstalled Cables
When testing uninstalled patch cables, the remote
unit can remain attached to the base of the main
unit's handle. Connect one end of the cable to be
tested to the main unit. Connect the other end
of the cable to the remote unit. Push the "TEST"
button to initiate the test. Note the LEDs present to
determine the cable's wiring status.
Testing Installed Cables
When testing installed patch cables, detach the
remote unit from the main unit's base to allow for
room-to-room testing. Using a jumper cable (not
included), connect the remote unit to the wall jack
or patch panel to be tested. Using a second jumper
cable (not included), connect the main unit to the
other wall jack or patch panel. Push the "TEST"
button to initiate the test. Note the LEDs present to
determine the cable's wiring status.
Once testing is completed, the remote unit will
securely snap into the base of the handle for easy
storage and transport.
Note: This product is designed to test cable lengths up to
600 ft./183 m.
4
01-155-9337F4.indb 4 2/20/2018 9:59:40 A