Oxygenics RAINBAR + BURST COMBO Guia De Inicio Rapido página 3

R B
AIN AR
INSTALLATION:
STEP 16
Holding the set screw in one hand and
hex key in other hand, place set screw into
hole located in the middle of the RainBar
housing. In a clockwise direction, install set
screw with 3 or 4 rotations until flush with
housing.
STEP 19
Thoroughly clean area where wall mount
will be applied.
STEP 22
Press wall mount firmly to cleaned area on
shower wall for 30 seconds. Remove back
covering from dome sticker and insert
dome sticker into hole on front of wall
mount.
+ B
URST
DRYWALL / TILE WITHOUT STUD
STEP 17
Attach end of 30" hose to top threaded
end of diverter and attach other end of
hose to threaded connection of RainBar.
Hand tighten only.
STEP 20
Remove covering from one side of
supplied adhesive strips and apply to back
of wall mount.
STEP 23
Attach end of 72" hose to base of
handheld and hand tighten.
C
OMBO
STEP 18
In a clockwise direction, screw end of 72"
hose to lower threaded end of diverter.
Hand tighten only.
STEP 21
Remove covering from adhesive strips
applied to back of wall mount.
STEP 24
Insert your new handheld shower in holder.
Enjoy!