Siemens SIRIUS 3RW4900-0NC00 Instructivo página 6

2. Activating the PROFINET communication module
Activate the "Fieldbus" device function
a) via the display or
b)via the device interface using the "Soft Starter ES 2007 + SP5" software (or a higher version)
NOTICE
After the communication module has been activated, default control priority automatically switches from the inputs to the
PROFINET communication module.
If an input with the "Manual operation local" function is active, the control priority does not change.
2.1 Activating the PROFINET communication module via the display
1. Upon initial commissioning you have to run through the quick start menu as described in the
Instructions (Order number: 3ZX1012-0RW44-0AA0).
2. Press the designated button on the device.
SIEMENS
3RW44
Menu
ESC OK
Parameter
1
set 1
select select
ESC OK
Fieldbus interface
1 Off
2
On
select select
ESC OK
3. The LED BUS flashes red.
If the fieldbus symbol
4. Under "Settings > Fieldbus" you can set various parameters. The following parameters must be set for initial commissioning:
Device name, IP address, subnet mask.
(see manual "PROFINET Communication Module", Order No. 3ZX1012-0RW40-0AB0)
5. In order to permanently save the settings, proceed as follows:
Saving 11
options
select select
ESC OK
6
Display mea-
1 1
sured value
select select
ESC OK
Saving
11
options
select select
ESC OK
Fieldbus interface
1 Off
2 On
select select
ESC OK
appears, the PROFINET communication module has been activated successfully.
Function call 1
Save
settings
select OK
ESC OK
Status display
2
select select
ESC OK
Fieldbus
10
select select
ESC OK
Fieldbus
1
interface
On
select change
ESC OK
Save
1
settings
execute ?
select accept
OK
ESC
"3RW44 Soft Starter" Operating
Settings
3
select select
ESC OK
Fieldbus
10
interface
Off
select change
ESC OK
SIEMENS
3RW44
Menu
ESC OK
3ZX1012-0RW40-0NA1