Technical Data - LauraStar COMPACT Instrucciones

MDE Compact 27.8.2001
Problems
Steam is escaping from the filling
cap
The iron is not getting hot
The iron is too hot
The handle is becoming hot
Steam keeps coming out of the
iron
Steam comes out irregularly
The steam is not under pressure

Technical Data

Steam pressure
Vertical ironing
Steam generator capacity
Able to use tap water
Mains supply
Steam generator power
16:08 Page 38
Possible causes
• The cap is not screwed on properly
• The cap is broken
• The mains plug is not pushed into the
wall socket
• The switches are switched off
• The thermostat is set to minimum
• The thermostat is badly adjusted
• The thermostat is set to maximum
• The iron switch is stuck
• The monotube is broken
• The holes in the soleplate are blocked
• The steam generator is empty
3,5 bar Iron power
Yes Total weight
0,85 l Weight of iron
Yes Dimensions of the closed unit
230V / 50 Hz Height of the table
1000 W
10
Solutions
• Retighten the cap correctly
• Do not use your unit any more and
contact your customer service agent
• Plug the mains into the wall socket
• Switch on the switches
• Adjust the thermostat correctly
• Lower the temperature using the
thermostat
• Lower the temperature using the
thermostat
• Depress the steam control button
rapidly and repeatedly
• Call your customer service agent
• As soon as the iron is cold clean
them
• Refill the steam generator
800 W
13.5 kg
1 kg
H135 x W44 x D18 cm
65 - 94 cm