Tripp-Lite U339-004 El Manual Del Propietario página 4

Offline Cloning
Notes:
• If your SATA hard drive has not been formatted yet, you will need
to format it using your computer's Disk Management utility before
proceeding with cloning.
• The Slave Drive (Bays B, C, D) capacity must be larger than that of the
Master Drive (Bay A). If its capacity is smaller or equal to the Master
Drive, you will not be able to clone information onto it.
• Prior to cloning, ensure there is no important data stored on the Slave
Drive. Once cloning begins, all data on the Slave Drive will be deleted
and replaced with the cloned data from the Master Drive.
• Be aware that the cloning process will take some time (approximately
2.5 hours per 1TB). Do not turn off power or remove hard drive before
the Progress LEDs indicate the process is completed.
• Offline cloning feature will not work if the U339-004 is connected to a
computer or any other source via USB cable.
1. Connect the included power supply to the unit and plug it into a
Tripp Lite Surge Protector, PDU, or UPS.
2. Set the PM/Clone switch on the rear of the dock to 'Clone'.
3. Insert the 2.5" or 3.5" SATA Master hard drive (the drive that
you want to clone) into The Master Drive (Bay A) of the docking
station.
4. Insert the 2.5" or 3.5" SATA Slave hard drive (the drive the
cloned data will be copied to) into the Slave Drive (Bay B) of the
docking station.
5. Insert any additional 2.5" or 3.5" SATA Slave hard drives into
the other available Slave Drives (Bay C and Bay D) of the
docking station.
18-11-303-93360E.indb 4
4
12/5/2018 5:19:52 PM