Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 178
5
5. GETTING STARTED (READ CAREFULLY)
Perform the colour fastness test below before using your Stain Remover Pen:
1. Moisten an inconspicuous area of the fabric with water.
2. Apply colourless liquid detergent.
3. Apply the Stain Remover Pen in this area following the instructions below.
4. Allow the fabric to dry. If it has not faded, you are clear to use your Stain Remover Pen.
CAUTION!
The Stain Remover Pen will operate continuously for 5 minutes before it is switched off to allow the
tip to cool. After 4 and a half minutes of use, the wand tip will begin to flash to indicate its maximum
cycle time has nearly been reached.
After a 1 minute pause, the wand can again be used normally.
CAUTION!
Use only neutral and colourless liquid laundry detergent, which is chlorine-free. Never use coloured
detergents or fabric softeners, as they can stain the fabric.
CAUTION!
This product is designed to remove stains up to 3 cm (about 1 inch) in diameter.
It is not suitable for use on old stains or stains from chlorine bleaches, mustard, non-removable inks,
solvents and other chemicals causing permanent damage.
CAUTION!
If the care label on your clothes says "wash separately" or "wash with similar colors", that usually
means that the dye isn't stable and is going to bleed or even rub off. You should wash your garment
at least 3 times according to the care label before to apply the Stain Remover Pen to avoid a possible
halo effect on unwashed dyed clothes. On darker fabrics reduce the application time.

Publicidad

Tabla de contenido
loading

Tabla de contenido