Atomic M01462AW Manual Del Usuario página 12

4 pcs - H1 M6 x 55mm Allen Head Bolt
2 pcs - H2 M6 x 46mm Allen Head Bolt
12 pcs - H6 Flat Washer
6 pcs - H8 Locknut
12. Attach the backboard to the frame. With the help of another adult start at the top hole, place
a H6 Washer on a H1 Bolt, pass the bolt through grommet of net and P10 Top Tube and
the backboard. Place a H6 Washer on the bolt and secure with a H8 Locknut as shown in
Detail E. Repeat for other side. At each bottom hole of the backboard, repeat the
above procedure except bring the ramp up behind the P8 Cross Tube, place the ramp tabs
over H1 Bolt and attach with H6 Washer and H8 Locknut as shown in Detail F.
13. Slide Cross Tube P8 through sleeve on the front of the ramp net, attach P8 Tube to Front
Connector Tube P5 and Front U-Tube P1 with Allen Head Bolts H2, Flat Washers H6 and
Locknuts H8 as shown in Detail G. Use T2 Wrench to tighten nuts.
14. Secure the Velcro Straps around the tubes.
P10
H1 H6
Detail E
Figure 10
All Rights Reserved.
© 2013 Escalade S por t s
!
PARTS REQUIRED:
P11
H8
H6
1 pc - P8 Front Cross Tube
1 pc - T1 Allen Wrench
1 pc - T2 Wrench
P8
H8
P8
H6
H2
P1
12
Detail F
P10
H1
H6
Ramp Tab on
backside of
P11 Backboard.
Note: Backboard on
backside of P10 Top
Tubes.
PLACE RAMP NET P16
BEHIND TUBE P8
P5
Detail G
For Customer Service Call 1-888-996-2729
P11
H8
H6