Aroma Function - Krups PRECISION Manual De Instrucciones

IFU_KR_COFFEE_MAKER_DAHLSTROM_MECA_Mise en page 1 23/11/10 09:47 Page22
English
A u t o - O f f f u n c t i o n :
n The heating plate will maintain the temperature in the jug for 2 hours
after which the machine shuts off automatically. This is for safety and
convenience.
n For best results brew only as much coffee as you will drink within 30-60
minutes.
P a u s e a n d S e r v e f e a t u r e :
n You can remove the jug during the brew cycles to pour an early cup.
Keep in mind that this will change the taste you would normally get from
a full pot in a complete cycle.
Be sure to replace the jug quickly (less than 20 seconds) to avoid over-
flow during the brew cycle.
For models with thermal pot : to ensure maximum heat retention, rinse
the thermal pot with hot water before use, and close the lid by turning clock-
wise.
WARNING :
Hot water continues to drip in the filter holder (h) when
the jug (f) is removed. The overflow of coffee and hot
water could cause burns.
Do not exceed the maximum capacity of the water tank as
shown by the water level indicator (g).
Place the ground coffee into the paper filter or directly
into a permanent filter.
Note : Pay attention to max level indicated on permanent filter.
After use, discard the grounds, and rinse the filter holder under run-
ning water.

AROMA FUNCTION

This function is designed specifically for small batches, normally less than
6 cups, where brew cycles become too short to properly extract the coffee
taste from the coffee ground.
n To activate press the Aroma button (n), then press On.
n When the appliance is powered up, a red light comes on (by
default, the Aroma pre-selection is "Normal" mode).
22