Checklist Before Starting Engine - Troy-Bilt 020210 Manual Del Propietário

Section 3: Assembly
2.
Similarly,attach other end of high pressure hose to
high pressure outlet on pump (Figure 5). Pull down on
collar of quick connect, slide onto pump and let go of
collar. Pull on hose to be sure of tight connection.
Connect high
pressure hose here
.
Before connecting garden hose to water inlet, inspect
inlet screen (Figure 6).
Clean screen if it contains debris, replace if damaged.
DO NOT RUN PRESSUREWASHERIF SCREEN IS
DAMAGED.
DO NOT use if
damaged, clean if
dirty.
4. Run water through garden hose for 30 seconds to
clean out any debris.Turn off water.
IMPORTANT: DO NOT siphon standing water for the
water supply.Use ONLY cold water (less than IO0°F).
5. Connect garden hose (not to exceed 50 feet in length)
to water inlet.Tightenby hand (Figure 6).
CAUTION
• Damageto equipment resulting from failure to follow this
instructionwill void warranty.
6. Turn ON water and squeeze trigger on spray gun to
purge pump system of air and impurities.
WARNING
Always wear eye protection when using this equipment or in
vicinity of where equipment is in use.
Before starting the pressure washer, be sure you are wearing
adequate eye protection.
Checklist Before Starting Engine
Review the unit's assembly to confirm you have performed
all of the following:
I. Make sure handle is in place and secure.
2. Check that oil has been added to proper level in
engine crankcase.
3. Add proper fuel to fuel tank.
4. Check for properly attached hose connections.
5. Check to make sure there are no kinks, cuts, or
damage to high pressure hose.
6. Provide a proper water supply (not to exceed IO0°F)
at an adequate flow.
7. Be sure to read "Safety Rules" and "HowTo Use
PressureWasher" before usingpressure washer.