STARLINK Volcano Mount Manual Del Usuario página 8

INSTALLATION ENGLISH
Install Instructions
1. Find stud on roof using a stud finder.
2. Place mount over stud and mark
six circles on roof.
3. Drill pilot holes into the size
marked circles.
4. Create six oversized balls from the
sealing tape squares and press over each
hole, overlapping the edges.
5. Set the two sealing tape strips over the six
holes where the Volcano Mount will sit.
6. Line the six holes on the mount over the six
pre-drilled holes. Starting with the center holes,
drive lag bolts ~90% in.
7. Use the socket wrench to tighten lag
bolts to be snug plus a quarter turn.
8. Place the Starlink and cable into the carrying
bag and carry to the install location.
Never set the Starlink directly onto roof.
9. Place the mast of the Starlink into the hole at the
center of the mount. Mount Starlink within 40° of vertical.
10. Unravel your connected cable coil. Route the
loose end into your home and connect to the power supply.
11. Use wall clips to fasten the cable to the wall
along your route. Avoid puncturing cable and
sharp bends, and follow horizontal / vertical lines.