MAISONS DU MONDE 158038 Instrucciones De Uso página 6

- Fill the kettle with water. Do not overfill.
- Place the kettle flush on the base.
- Electrical connection :
- Check whether the electrical voltage that you intend to use is the same as that of the machine. Details are to be found on the label
on the base.
- Only connect the machine to a properly according to the requirements of the rating label.
- Switch the machine to position «1».
- After boiling, the machine switches off automatically. Disconnecting the machine from the mains electricity supply. Do not press
up the lid when pouring.
OPERATION
POSITIONING THE KETTLE
- Position the power base on a dry flat surface away from any potential heat source.
- The underside of the power base is fitted with a cable storage feature. Unwind the length of mains cable required to reach the mains
socket .
- Ensure the mains cable does not hang over the work surface edge.
- Do not operate this kettle without the filter fitted .
FILLING
- Remove the kettle from the power base .
- Open the lid .
- Fill the kettle between the MIN and MAX markings on the water level indicator with cold water .
- Close the lid and place the kettle back on the power base. Make sure the lid is securely closed before boiling.
CLEANING
- Always remove the plug from the mains supply and allow it to cool down completely before cleaning the machine.
- Clean the outer surface with a soft damp cloth only .
- Remove stubborn spots using a cloth moistened with mild detergent.
- To keep this kettle in good condition NEVER use steel wool, chemical, wooden or abrasive cleaners to clean the outside of the kettle
- When not in use or in storage , the power cable may be wound under the bottom of the kettle .
- Cleaning the filter : The filter is located just behind the spout. Before removing or assembling the filter, switch the kettle off and empty it.
Allow it to cool completely then unplug the power base from the mains power supply.
- Filter removal and reassembly :
1. Pull the filter outwards until it unclips.
2. Rinse the filter in warm water and gently remove any scale with a soft brush.
3. To reassemble, place the bottom of the filter onto the holding lug inside the kettle then clip into the lug at the top of the filter under the
rim of the spout. The filter will only fit one way.
DECALCIFICATION
Decalcification refers to removing the calcium deposits which may form on the interior metal parts of the kettle .
To get the best performance from your kettle ， descale your kettle from time to time . Frequency depends on the hardness of your tap
water and how often you use the kettle .
We suggest use of a kettle descaler in order to dissolve these chalky deposits or scale.
Follow the directions on the descaler package . If a commercial descaler is not available ,fill the kettle with enough white vinegar to
cover the bottom by about 1.5cm. Bring the vinegar to a boil. You may need to repeat this several times with cooled vinegar to remove
the calcium build-up completely. When the descaling process is complete, empty the kettle and rinse out several times with clean water.
6