Publicidad
Idiomas disponibles
Idiomas disponibles
4.
Then connect the audio receiver using the supplied audio adapter to an au-
dio output device. This may be, for example, a hi-fi system.
5.
To turn the device on or off, press and hold the multifunction button on
the front panel for about 2-3 seconds. The LED in the button starts flashing.
6.
If you disconnect the device from your audio playback device, the Bluetooth
receiver turns off automatically after about one minute.
Note: Charge the battery fully once again, if the receiver switches off in battery
mode or if it cannot be switched on.
4. Establishing a Bluetooth connection
1.
Turn on the Bluetooth audio receiver by pressing and holding the multifunc-
tion key for about 2-3 seconds. The button is located on the front of the
device.
2.
The LED indicator on top starts flashing. The Bluetooth audio receiver then
waits for a connection.
3.
Enable the Bluetooth interface on your audio playback device (e.g., a Smart-
phone) and perform a scan. Then pair the device using "aplic-303673". The
connection has now been established successfully with the Bluetooth audio
receiver.
Note: Switch off the audio receiver for about 20 seconds and try to pair again if the
connection could not be established.
5. Bluetooth calls
You can answer incoming calls by pressing the multifunction button briefly during
an incoming call. You can hang up by pressing the multifunction button briefly
during a call.
English
9
Publicidad
