First Use; Charging - ANSMANN PL210R Manual De Instrucciones

§ Do not open or modify the product! Repair work and replacement of the rechar-
geable battery pack shall only be carried out by the manufacturer or by a service
technician appointed by the manufacturer or by a similarly qualified person.
§ Keep the product and the packaging away from children. This product is not a toy.
Children should be supervised in order to ensure that they do not play with the product.
§ This product is not to be used by persons (including children) who have res-
tricted physical, sensory or mental capabilities or who do not have adequate
experience and knowledge in handling this product. Such persons must be
instructed beforehand by a supervisory person who is responsible for their
safety or must be supervised during the use of the product!
§ The LED light source cannot be replaced. When the LED comes to the end of its
service life, the complete lamp must be replaced
§ All illuminated objects must be at least 10cm away from the light!
§ The lamp may only be used in accordance with the intended use.
§ This product is not a toy to be played with.
§ Keep out of the reach of children!
§ Failure to observe the safety instructions can result in dangerous injuries to
persons or damage to the device!
§ Always keep the product dry
ATTENTION:
§ The product contains a non-replaceable Li-Ion-rechargeable battery. Do not
throw the product into a fire!
§ The product may only be charged in closed, dry and spacious rooms, away from
combustible materials and liquids. Disregard can result in burns and fires.
§ Never open, crush or heat a rechargeable battery or set it on fire.
§ Do not use the product in potentially explosive areas or in the rain and do not
expose it to excessive heat.
§ Do not use the product if it appears to be damaged

FIRST USE

Press on/off button:
1x TOP LED on
2x Main LED on
3x Lamp off

CHARGING

1. Charge the workshop lamp fully before using for the first time. If the lamp has
been stored for an extended period of time, it should also be charged before
use; charge regularly during longer periods of non-use.
2. Switch the lamp off before charging. For charging, pull the sealing cap off the
micro-USB socket. Connect the USB charger to the lamp by plugging the mic-
ro-USB plug on one end of the USB/micro-USB charge cable into the micro-USB
socket on the lamp and plugging the USB plug on the other end of the charge
cable into the USB socket of the USB charger.
Deutsch | English
Svenska | Italiano | Nederlands | Portuguese
| Français | Español
11