Inseego FW2000e Manual De Instalación página 5

Installing the PoE cable
1. Remove the installation PoE cable used for
the location survey from the device using
needle nose pliers or tweezers.
2. Remove the rubber pin from the PoE gland
bushing and assemble the gland cap,
putting the bushing inside the spacer and
into the cap.
Rubber pin and
gland bushing
3. Thread the permanent PoE cable through
the hole in the assembled PoE gland cap and
attach a RJ45 connector to the cable.
4. Insert the connector into the FW2000e and
screw on the gland cap. The cap will keep
the PoE connection secure and watertight.
Gland cap assembly
English