Publicidad
Idiomas disponibles
Idiomas disponibles
Installing the mount
The mount is adjustable and can be mounted on
vertical, horizontal, and slanted exterior surfaces.
The mount is attached using the four roof mount
lag screw in the corners of the base.
Roof mount lag screw
1. Pre-drill holes in the surveyed location.
2. Attach the mount using a hex driver to tighten
the lag screws.
NOTE: Concrete anchors are provided if
mounting to concrete or brick.
Securing the device elevation bracket to the
mount
1. Attach the device elevation
bracket to the mount and
tighten the square neck
bolts along the back to
2.0 Nm using a ratcheting
socket wrench.
2. Ground the ground wire
to an appropriate earth
ground.
English
Publicidad
