Ec Declaration Of Conformity; Mains Connection - Milwaukee MDP 41 Manual Original

página de 106

/ 106
Contenido
Tabla de contenido
Marcadores

Tabla de contenido

Idiomas disponibles

mm. The magnetic base WILL NOT hold on nonmagnetic grades of

stainless steel.

The substrate under the drill stand has to be clean, rm, smooth,

dry, without polish and not have any holes in it.

Do not expose the drill stand to rain and do not use in damp or

non- ameproof rooms.

Keep constant pressure throughout the entire operation to prevent

chips and burrs from falling under the cutting edges. Cutting debris

under the cutter can make cutting di cult or impossible.

WARNING!

Excessive force will break magnet free.

Avoid contact with cutter tips. Periodically inspect the cutter tips

for loose or damaged tips.

The use of cutting uid is recommended for long life of these

cutters.

Secure the magnetic drill stand with the provided safety harness

when working slanting or vertical surfaces, or overhead such that it

won't fall down in case of power loss.

The safety harness must be applied such that the drill stand will

move away from the user in case of power loss.

Check safety belt for any damage and wear before every use. Do not

use defective safety belts!

The insertion tool may become hot during use.

WARNING! Danger of burns

• when changing tools

• when setting the device down

Do not remove cutter unless slug is removed. Slug may eject

unexpectedly.

AUTO STOP

AUTO-STOP switches the machine o automatically if there is a

too high, jerky operating torque on the magnet. Determine and

rectify the cause of the automatic stop by referring to the safety

information.

Possible causes can be:

• breakage of the material to be used

• excess load of the electric tool as a result of too high a feed rate

• unclean magnetic surface

Switch the machine o and then switch it back on again.

RESTART CUTOUT

If the machine is still switched on it will not restart after a power

failure. To restart it the machine must be switched o and then

on again.

MOTOR/MAGNET INTERLOCK

The motor/magnet interlock is a feature that prevents power from

being applied to the drill motor if the magnet is not energized.

The motor magnet interlock also prevents the magnet from being

de-energized while the motor is running.

MAINS CONNECTION

Connect only to a single-phase AC current supply and only to the

mains voltage speci ed on the rating plate. Must only be used from

sockets with earth wire.

Pre-connect a residual current device (FI, RCD, PRCD.

Only plug-in when machine is switched o .

Keep mains lead clear from working range of the machine. Always

lead the cable away behind you.

English

MAINTENANCE

Before use check machine, cable, safety harness and plug for any

damages or material fatigue. Repairs should only be carried out by

authorised Service Agents.

The ventilation slots of the machine must be kept clear at all times.

From time to time, apply a few drops of oil to the rack toothing. The

bearings of the feed shaft are self-cutting and must not be greased.

Grease the sliding surface of the carriage with Molykote grease.

Clean dust and debris from tool. Keep tool handles clean, dry and

free of oil or grease. Use only mild soap and a damp cloth to clean

the tool since certain cleaning agents and solvents are harmful

to plastics and other insulated parts. Never use ammable or

combustible solvents around tools.

Use only Milwaukee accessories and Milwaukee spare parts. Should

components need to be replaced which have not been described,

please contact one of our Milwaukee service agents (see our list of

guarantee/service addresses).

If needed, an exploded view of the tool can be ordered. Please

state the Article No. as well as the machine type printed on the

label and order the drawing at your local service agents or directly

at: Techtronic Industries GmbH, Max-Eyth-Straße 10, 71364 Win-

nenden, Germany.