Maintenance Plan; Disposal; Troubleshooting - IKRA ITHK 1000 Instrucciones De Manejo

Warning! Always remove the plug before checking and setting work.
Replacing the guide bar and saw chain
WARNING
Wear protective gloves.
A dull or improperly sharpened chain can cause
excessive motor speed during cutting which may
result in severe motor damage.
Failure to replace or repair a damaged chain can
cause serious injury.
The saw chain is sharp. Always wear protective
gloves when performing maintenance to the chain.

Maintenance plan

Daily check
Bar lubrication
Chain tension

DISPOSAL

If your device should become useless somewhere in the
future or you do not need it any longer, do not dispose
of the device together with your domestic refuse, but
dispose of it in an environmentally friendly manner.

TROUBLESHOOTING

Problem
The hedge trimmer
does not run.
Not enough power,
not running
smoothly
If you are unable to rectify the problem, contact our service department (details
provided on the warranty card) or find a specialist workshop.
Before each use
Before each use and
frequently
Potential causes
No electricity
House fuse or residualcurrent
circuit breaker has
been tripped.
The motor overload
protection has triggered
because the motor has
been overloaded or has
overheated.
The hedge shears have
been jammed by plant
remains or foreign objects
(e.g. a piece of wire).
Hedge shears are dull or
damaged.
Chain sharpness
For damaged parts
For loose fasteners
Chain brake function
Guide Bar
Complete saw
Replacement parts
Spool 78001921
Blade 73040106
Chain Oregon 91PX033X
Guide Bar 080SDEA318
Chain must be fitted with bar from the same
manufacturer according to above combinations.
Please dispose of the device itself at an according collec-
ting/recycling point. By doing so, plastic and metal parts
can be separated and recycled. Information concerning
the disposal of materials and devices are available from
your local administration.
Solutions, tips
Check whether the hedge
trimmer is connected to mains
electricity.
Check the extension cord for
damage.
Let the hedge trimmer cool off
for 15–20 minutes.
Disconnect the hedge trimmer
from the mains first. Inspect the
hedge shears and remove any
foreign objects.
Have the hedge trimmer
checked by a specialist
workshop.
GB ENGLISH
Before each use, visual
check
Before each use
Before each use
Before each useInspect
and clean
Before each use
After each use
37