Water Ace R1030 Manual Del Usuario página 3

14. Protect electrical cord from sharp objects, hot surfaces, oil,
and chemicals. Avoid kinking cord. Replace or repair dam-
aged or worn cords immediately.
15. Do not touch an operating motor. Modern motors are
designed to operate at high temperatures.
Risk of electric shock. If your basement has
water or moisture on the floor, do not walk on wet area until
all power has been turned off. If shut-off box is in basement,
call electric company or hydro authority to shut-off service to
house, or call your local fire department for instructions.
Remove and replace system. Failure to follow this warning can
result in fatal electrical shock.
Risk of electric shock. Do not handle pump or
pump motor with wet hands or when standing on wet or damp
surface, or in water. Always disconnect the pump and switch
from the electrical power source before doing any mainte-
nance.
16. Pump water only with this pump.
ASSEMBLY
Steps 1 and 2 (See Figure 1)
2
Figure 1
Step 3 (See Figure 2)
3
Figure 2
1
Step 4 (See Figure 3)
Install the discharge pipe hand-tight plus one-half turn.
4
Figure 3
Step 5 (See Figure 4)
Place the pump in the basin as shown. Align the discharge
with one of the threaded ports in the cover.
1
1 " NPT
2
Discharge
Inlet
Figure 4
Step 6 (See Figure 5)
Turn the cover upside down and 'lay in' the basin gasket as
shown.
Locating
Cleats
Figure 5
3
1
1 " NPT
2
Vent
Pump
Basin
WA483