Proxxon MICROMOT 230/E Manual página 15

brush. The wire bristles can easily penetrate light
clothing and/or skin.
b) Allow brushes to run at operating speed for at
least one minute before using them. During this
time no one is to stand in front or in line with the
brush. Loose bristles or wires will be discharged
during the run-in time.
c) Direct the discharge of the spinning wire
brush away from you. Small particles and tiny
wire fragments may be discharged at high ve-
locity during the use of these brushes and may
become imbedded in your skin.
For use in dry environments only
Wear safety glasses!
Protection class II device
Do not dispose of the electrical device in
household waste!
1 Legend (Fig. 1):
1. ON/OFF switch
2. Speed control knob
3. Device bracket
4. Connecting cable
5. Motor housing
6. Lock button
7. Sleeve nut with steel collets
8. Housing nut with 20 mm fi t
2 Description of the device:
The Micromot 230/E is ideally suited to tasks
such as precision drilling, milling, grinding,
polishing, brushing, rust removal, engraving,
chasing and cutting and, as a compact,
lightweight but still powerful device, is the fi rst
choice for electronics technicians, model
builders, precision
manufacturers, opticians and arts and crafts
professionals and
construction. Complete fl exibility is assured
when it comes to selecting the material to be
mechanics, jewellery
for die and mould
machined, thanks to our familiar and extremely
broad range of varied operational tools.
Machining of metals, non-ferrous metals,
glass, wood, minerals, ceramics, stone and
much more no longer presents a problem!
A carefully balanced permanent magnet DC motor
with extremely smooth running characteristics
provides powerful torque in this respect and,
in conjunction with the sensitive electronic
control, ensures the correct speed for the tool
employed and the task in hand.
The ground spindle with the collet holder is
mounted on precision ball bearings for maximum
precision, durability and smooth running.
Superior-quality, three-jawed collet chucks are
used for tool holding. This enables the reliable
and absolutely centric clamping of even smaller
shafts, fulfi lling the optimum prerequisites for
fi rst-class concentricity and clean working results!
An ergonomically positioned non-slip soft
component on the forward part of the Micromot
230/E enables the user to exploit all these
advantages and facilitates precision guiding
without fatigue. Even two-fi ngered guiding of the
device presents no problem.
Provisions have also been made for use with
our drill stand or similar accessories, with the
Micromot 230/E incorporating the familiar 20 mm
system fi t in this respect.
3 Scope of delivery:
1 x Micromot 230/E
1 x Operating instructions and safety guide
lines
1 set Steel collets (1 - 1.5 – 2 - 2.4 - 3 and
3.2 mm)
- 15 -