Extension Cord; Functional Description - Porter Cable PC750RS Manual De Instrucciones

90546363 PC750RS PC850RS

EXTENSION CORD

When using an extension cord, be sure to use one heavy enough to carry the current
your product will draw. An undersized cord will cause a drop in line voltage resulting in
loss of power and overheating. The following table shows the correct size to use
depending on cord length and nameplate ampere rating. If in doubt, use the next
heavier gage. The smaller the gage number, the heavier the cord.
Volts
120V
240V
Ampere Rating
More
Than
0 -
6 -
10 -
12 -
MOTOR
Be sure your power supply agrees with nameplate marking. 120 Volts AC only means
your tool will operate on standard 60 Hz household power. Do not operate AC tools on
DC. A rating of 120 volts AC/DC means that your tool will operate on standard 60 Hz
AC or DC power. This information is printed on the nameplate. Lower voltage will cause
loss of power and can result in over-heating. All Porter Cable tools are factory-tested; if
this tool does not operate, check the power supply.
SAVE THESE INSTRUCTIONS
B
C
E
H

Functional Description

A. Trigger Switch
B. Blade Clamp Release Lever
C. Shoe
D. Main Handle
12/9/08 8:54 AM Page 5
Minimum Gage for Cord Sets
Total Length of Cord in Feet
0-25 26-50 51-100
(0-7,6m) (7,6-15,2m) (15,2-30,4m) (30,4-45,7m)
0-50 51-100 101-200
(0-15,2m) (15,2-30,4m) (30,4-60,9m) (60,9-91,4m)
Not more American Wire Gage
Than
6 18 16 16
10 18 16 14
12 16 16 14
16 14 12 Not Recommended
G
E. Secondary Gripping Handle
F. Variable Speed Selector Wheel (PC850RSO)
G. Blade Action Selector (PC850RSO)
H. Adjustable Shoe Button (PC850RSO)
5
101-150
201-300
14
12
12
A
D
F