cecotec Conga 2690 Manual De Instrucciones página 42

ENGLISH
The robot cannot charge or return to the
charging base.
The robot does not work properly.
The robot emits a strange noise during
cleaning.
The robot does not clean efficiently or dust
leaks from the robot.
The robot could not connect to Wi-Fi.
42
There are too many obstacles near the
charging base, relocate the charging base to
an area free of obstacles.
Clean the charging terminals.
Make sure the power switch is turned on.
The robot is too far away from the charging
base, place it closer and try again.
There is very little free space around the
charging base. Make sure the charging
terminals are clean.
Turn the robot off, switch it off and turn it on
again.
Once the robot has been switched on and it
is not in its base, keep pressed the robot's
"Home" button until it beeps. Immediately
release the button and press it again until the
robot beeps again. This will reset the robot.
The main brush, side brush or omnidirectional
wheel may have foreign matters tangled, stop
the robot and clear it up.
The dust tank is full. Empty it and clear the
high-efficiency filter if it is blocked.
The high-efficiency filter is blocked, clear it.
The main brush is tangled with foreign matter,
please clear it up.
The Wi-Fi signal is poor. Make sure the Wi-Fi
signal is correct.
The Wi-Fi connection is unstable. Reset the
router, check if there are any App updates and
try again.
Make sure that the mobile data in your
device are disconnected in order to improve
the linking process.