Supplementary Safety Instructions For Working With Wire Brushes; Original Accessories/Auxiliary Equipment; Use; Changing/Inserting The Tool/Collet Chuck - Parkside PGS 500 A1 Traducción Del Manual De Instrucciones Original

Supplementary safety instructions
for working with wire brushes
Special safety instructions for working with
wire brushes:
a) Be aware that the wire brush loses wire
bristles even during normal operation. Do
not overstress the wires by applying exces-
sive pressure to the brush. The wire bristles
can easily penetrate thin clothing and/or skin.
b) Allow the brush to run at working speed
for at least one minute before applying
it to the workpiece. Ensure that no one is
standing in front of or in line with the brush
during this time. Loose pieces of wire can
become airborne during the run-in period.
c) Aim the rotating steel brush away from
yourself. When working with these brushes,
small particles and minute pieces of wire can fly
off at great speed and pierce skin.
Original accessories/auxiliary
equipment
■ Use only the accessories and auxiliary equip-
ment that are specified in the operating instruc-
tions and are compatible with the appliance.
│ GB │ IE
■ 20

Use

Changing/inserting the tool/collet
chuck
♦ Press the spindle lock
♦ Loosen the tensioning nut
using the assembly wrench
♦ Remove any tool that may be inserted.
♦ First, push the intended tool through the tension-
ing nut before inserting it into the appropri-
ate collet chuck
♦ Press the spindle lock
♦ Push the (6 mm) collet chuck
insert and screw the tensioning nut
the assembly wrench
♦ To use the (3.2 mm) collet chuck
into the pre-assembled (6 mm) collet chuck
■ Observe the manufacturer's recommendation
for small grinding tools. The maximum permissi-
ble protrusion (L0 = length of the shaft between
the collet chuck end and the small grinding
tool) specified by the manufacturer must not be
exceeded when using small grinding tools! If
the protrusion (L0) is increased, the permissible
rotation speed must be lowered. Wherever pos-
sible, insert the complete length of the shaft of
the accessory tool into the collet chuck. Ensure
that the clamping length (Lg) is at least 10 mm.
Only use attachment parts with a maximum
mandrel length of 40 mm.
L o

Grinding stone

♦ Grinding work can be performed on various
metals using the grinding stone
and hold it down.
from the thread
.
for the tool shaft.
and hold it down.
into the thread
tight with
.
, insert it
L
g
.
PGS 500 A1
.