Access The Internet Using The Ethernet Port (Access Point); Network Share; How To Enable Network Share - Kingston MobileLite Wireless Pro Manual Del Usuario

Access the Internet Using the Ethernet Port (Access Point)

If you have a wired internet connection, you can plug an Ethernet networked cable to the Ethernet port on
the Kingston MLWPRO. This would allow you to create an access point for wireless internet access.
While connected to the Ethernet bridge mode, the Wi-Fi bridge mode will be disabled temporally until the
Ethernet cable is removed.
NOTE: Only compatible with DHCP.
Simply connect an Ethernet networked cable to the
Ethernet port on the MLWPRO device. Check that
bridged LED is ON to verify that you have a
successful connection to the router.
If you haven't already, make sure to connect to the
MLWPRO network.

Network Share

Once internet access on the MLWPRO is enabled (bridged), you can enable 'Network Share' and have
access to your media without changing the mobile device's Wi-Fi settings as long as the mobile device is
connected to the same network you used to bridge the MLWPRO.

How to Enable Network Share

1. Click 'Settings' at the bottom of the MLW app screen.
2. Click 'MLW Setup' and on the next screen click 'Wireless Setup'.
1
Continued on next page...
Document No. iOS-MLWPRO-011816.A00
2
MobileLite Wireless Pro
Bridged
LED
3
Page 25 of 29