Courtyard Creations TGS66PW Instrucciones De Montaje

ASSEMBLY INSTRUCTIONS
ATTENTION: THIS PRODUCT IS NOT FOR COMMERCIAL USE
PARTS LIST
PART
MATERIAL CODE
NO.
1
TGS66PW-CS01
2
TGS66PW-CS02
3
TGS66PW-CS03
4
62TGS66PWY101
You will need the following tools:
- Phillips Screwdriver (Not included)
- Hex.Key Wrench (See part #7)
- Hex.Key Wrench (See part #8)
Step 1:
Place the table top (#1) onto a non–abrasive surface,
such as a carpet, with its underside facing upwards.
Insert the legs (#3) and the supports (#2) into the plastic
holders attached on the underside of the table top (#1)
rim. Fasten them together by using screws (#5).
See Figure 1.
Use the correct bolts as indicated. Do not tighten any of the bolts until the table is completely assembled.
!
Do not sit or stand on this table.
!
A weighted umbrella base must be used when using an umbrella with this table.
!
Do not discard of any of the packaging until you have checked that you have all of the parts and
!
fittings required.
Keep children away during assembly. This item contains small parts that can be swallowed by
!
children. Children should always be under direct adult supervision while using this product.
Retain these assembly instructions for future reference.
!
Quote the following FQC NO. when contacting the service center.
!
V-3
INTENDED FOR RESIDENTIAL USE ONLY.
PART
TABLE TOP
SUPPORT
LEG
CENTER
CONNECTOR WITH RING
SERVICE CENTER TOLL FREE NO.
DON'T RETURN TO STORE!
STOP
TGS66PW
PART
Q'TY MATERIAL CODE
NO.
1 5
17C17A0403001YX
2 6
17C40A0709001YX
4 7
17KAA0101----Y4
1 8
17KAC3101----Y3
FIGURE 1
3
TEL: 1-877-539-7436
FAX: 1-877-539-7439
PAGE 1 OF 2
PART
SCREW ST4.2*12
BOLT M6*25
HEX.KEY WRENCH 4MM
HEX.KEY WRENCH 10MM
3
3
3
2
2
1
COURTYARD CREATIONS INC.
Q'TY
6
12
1
1
5