Courtyard Creations TGS27SV Instrucciones De Armado

ASSEMBLY INSTRUCTIONS
ATTENTION: THIS PRODUCT IS NOT FOR COMMERCIAL USE
PARTS LIST
PART
MATERIAL CODE
NO.
1
TGS27SV-CS01
2
TGS27SV-CS02
3
62TGS28SHY101
4
17C17A0403001YX
You will need the following tools:
- Phillips Screwdriver (Not Included)
- Hex. Key Wrench (See Part #7)
- Hex. Key Wrench (See Part #8)
Step 1:
Place the table top (#1) onto a non-abrasive surface,
such as a carpet, with its underside facing upwards.
Insert the legs (#2) into the plastic holders attached on
the underside of the table top (#1) rim. Fasten them
together by using screws (#4). See Figure 1.
Use the correct bolts as indicated. Do not tighten any of the bolts until the table is completely
!
assembled.
Do not sit or stand on this table.
!
Do not discard of any of the packaging until you have checked that you have all of the parts and
!
fittings required.
Keep children away during assembly. This item contains small parts that can be swallowed by
!
children. Children should always be under direct adult supervision while using this product.
Retain these assembly instructions for future reference.
!
Quote the following FQC NO. when contacting the service center.
!
V-3
INTENDED FOR RESIDENTIAL USE ONLY.
TGS27SV
PART Q'TY
TABLE TOP
LEG
CENTER CONNECTOR
SCREW ST4.2*12
SERVICE CENTER TOLL FREE NO
TEL: 1-877-539-7436
FAX: 1-877-539-7439
STOP DON'T RETURN TO THE STORE!
PAGE 1 OF 2
PART
MATERIAL CODE
NO.
1 5
17C40A0705001YX
4 6
17FC05020601-YX
2 7
17KAA0101----Y4
4 8
17KAC3101----Y3
FIGURE 1
2
2
1
PART
BOLT M6*15
WASHER d6.5*D10*1.6
HEX. KEY WRENCH 4MM
HEX. KEY WRENCH 10MM
2
2
COURTYARD CREATIONS INC.
Q'TY
8
8
1
1
4