Fitting The Blades - Sun joe 24V-SSEG-CT Manual Del Operador

m
WARNING!
This charger does not automatically turn off
when the battery is fully charged. Please take care not to leave
the battery plugged into the charger. Switch off or unplug the
charger at the mains when charging is complete.
5. Timely recharging of the battery will help prolong the
battery's life. You must recharge the battery pack when
you notice a drop in the equipment's power.
IMPORTANT! Never allow the battery pack to become fully
discharged as this will cause irreversible damage to the
battery.
6. When charging is complete, remove the battery from the
charger by pulling the push lock button and sliding the
battery backward to unlock it from the charger.
Assembly
m
WARNING!
Always remove battery pack from the tool
when you are assembling parts, making adjustments, cleaning,
or when not in use. Removing battery pack will prevent
accidental starting that could cause serious personal injury.
m
WARNING!
Do not use any attachments or accessories
not recommended by the manufacturer of this product.
The use of attachments or accessories not recommended can
result in serious personal injury.
m
CAUTION!
Wear protective gloves before handling the
blades.
m
WARNING!
Make sure the unit is powered off before
handling the blades.

Fitting the Blades

1. To fit the blades, turn the unit upside down on a hard
surface, align the blade cover tab with the slot in the
motor housing and place it into position (Figs. 4 – 5)
Fig. 4
Blade cover tab
Slot
Motor housing
Blades
Fig. 5
2. Place the blade cover down and make sure it clicks into
place with the tabs on the motor housing (Fig. 6).
Slots
Fig. 6
Tabs
3. Make sure the latches on each side of the blade cover
snap into place and that the blade is secured in the
product before beginning operation (Figs. 7 – 8).
Fig. 7
Blade
10
Blade cover tab
Blade cover
Latch