Disinfection; Maintenance - Gima RS01 Manual De Usuario

37
 The temperature of the device cleaning water is below 60°C.
 Never permit any liquid run into the device,nor submerge the device into any
liquid.
 Never spoil liquid on the device when cleaning.
 Never remain any solution on the surface of the device.

7.2 Disinfection

After cleaning the device with the methods above, disinfect it with medical alco-
hol, then air-dry (or with dry cloth).
Notes:
 Never disinfect the device with the method of low temperature steam or high
temperature.
 Never use electron shoot bind or other methods to disinfect.

7.3 Maintenance

Before using the device,check it for evident damages which may possibly affect
patient's safety. We recommend the check period is once a month (or shorter
period). In case of evident damage,it is recommended to replace the damage
parts before using.
The device is precise electrical equipment,take and put it carefully. For a longer
service life, take the following measures to maintain the device.
1) When the battery is in low power, recharge it in time.
2) After fully discharged,the battery should be recharged as soon as possible.
If the device is not used for long, you shall make entire charge/discharge oper-
ation every 6 months.
3) Please clean and disinfect the device before using it on patient.
4) Disinfect the device after use in case not cause cross infection in use again.
The device determines its accuracy, which can not adjusted by user. If there
is any doubt about the measurement result, use other methods to verify, or
contact your local agent or manufacturer for help.
Notes:
 Maintaining this device must be carried out by our company's authorized and
qualified engineer.
 If not in use for long,clean, disinfect this device and save it in the packing case,
then put it in a draughty place without caustic gas.
ENGLISH