Zest LOCATOR Instrucciones De Uso

Instructions for Use: LOCATOR
Male Removal Tool
NOTE: The new Abutment Retaining Sleeve for use with the LOCATOR
available separately from the Core Tool in a 4 pack or 20 pack, (Zest order numbers 8394 and 8394-20). To use
the driver with sleeve start with Step 1. To remove and replace the LOCATOR
STERILIZATION
®
LOCATOR Core Tools (in the disassembled state only) may be sterilized by Autoclave or Dry Heat sterilization
using the following parameters:
1. Autoclave sterilize using 121° C (250° F), (15-20 psig at sea level), for 40 minutes minimum.
2. Dry Heat sterilize using 170° C (338° F) for 2 hours minimum.
NOTE: The Abutment Retaining Sleeve has been validated to withstand five (5) autoclave sterilization cycles
using parameter no.1 above.
1. The sleeve (Zest order number 8394) slips onto the driver end of LOCATOR
®
a LOCATOR Abutment onto the driver, allowing the driver/sleeve and abutment to be held vertically without
abutment falling off the driver, making it easier to deliver the abutment to the patient's implant.
2. Loosen the (8397) Male Removal Tool a full 3 turns counter clockwise (you will see a visible gap).
3. To remove a LOCATOR
assembly and push straight in to the bottom of the nylon male. Then tilt the tool so that the sharp edge of the tip
will grab hold of the male and pull it out of the cap.
4. To discard the nylon male from the tip on the Core Tool; point the tool down and away from you and tighten the
Male Removal Tool clockwise back onto the Core Tool. This will activate the removal pin and dislodge the nylon
male from the tip end of the Male Removal Tool.
5. Separate the Male Removal
the remaining two sections to place a new nylon male into the empty titanium metal housing.
L8009-M REV. C 2/10
®
CORE TOOL (with Abutment Retaining Sleeve)
Male Seating Tool
Gap
®
nylon male from the titanium metal housing; simply insert the tip into the cap/male
Tool
section from the LOCATOR
Male Seating Tool End
®
Core Tool is pictured above. It is
®
Male start with Step 2.
®
Core-Tool, and is designed to hold
®
Core Tool and use the Male Seating Tool end of
®
LOCATOR is a registered trademark of ZEST IP Holdings, LLC
Abutment Driver Sleeve