Setting The Clock; Using The Timer - Krups PRELUDE Manual De Instrucciones

notice km1000_0828049.qxd:0828049
English
USING THE PROGRAMMABLE TIMER
-- Clock / Timer available only on specific models --
S e t t i n g t h e C l o c k :
The clock must be set to the correct time before using the programmable brewing function. To set the clock
press the Hours button (H) and the Minutes button (Min). The clock shows AM or PM near the bottom of the
display.
P r o g r a m m i n g t h e t i m e r :
Press the Program button (PROG). The On/Off button will blink with a blue light. You can only program the
start time while the On/Off button is blinking with blue light.
If the function becomes inactive while you are entering the time press program (Prog) to reactivate this function.
When the programmed start time is set the machine will validate automatically after 5 seconds and shut-off.
To a c t i v a t e t h e t i m e r :
Press the AUTO button and the On/off button will show a solid blue light. Brewing will not begin until the time
that was set in the Program function (above).
Be sure to prepare the machine for a brew cycle with water in the tank, coffee in the brew basket and carafe
securely in place.
At the programmed time the machine will automatically turn on and start a brew cycle. The On/Off button will
glow red while brewing.
The preset time is retained in memory so subsequent automatic brew cycles for the same preset time can be
activated by simply pressing the Auto button.
CLEANING
Used ground coffee and the paper filter can be disposed in the trash or compost. Do this soon after brewing.
If possible do not let wet coffee sit in the machine overnight.
8
23/04/08 16:04
• The filter basket holder has a handle to allow easy disposal of the
grounds.
• The filter basket holder should be cleaned regularly with soap and water.
Page 10