Assembly; Unpacking The Generator; Install Wheel Kit - Husqvarna 1365GN Manual Del Operario

Assembly
ASSEMBLY
Your generator requires some assembly and is ready
for use after it has been properly serviced with the
recommended oil and fuel.
If you have any problems with the assembly of your
generator, please call the generator helpline at
1-877-224-0458. If calling for assistance, please have
the model, revision, and serial number from the data
tag available.
Unpacking the Generator
1. Set the carton on a rigid flat surface.
2. Remove everything from carton except generator.
3. Open carton completely by cutting each corner
from top to bottom.
4. Leave generator on carton to install wheel kit.
Carton Contents
Check all contents. If any parts are missing or damaged,
call the generator helpline at 1-877-224-0458.
• The generator
Generator and engine operator's manuals
• Locking 30 Amp plug
• Battery charge cables
• Engine oil
Wheel kit
Install Wheel Kit
The wheel kit is designed to greatly improve the
portability of your generator.
NOTE: Wheel kit is not intended for over-the-road use.
You will need the following tools to install this wheel kit:
• 7/16" and 13mm socket wrenches
• 7/16" and 13mm open end wrenches
• Pliers
• Safety glasses
Refer to Figure 1 and install the wheel kit as
follows:
1. Tip generator so that engine end is up.
2. Slide axle through both mounting brackets.
3. Slide a wheel over the axle.
NOTE: Be sure to install both wheels with the air
pressure valve on the outboard side.
Handle Pin
Nylon Washer
45 mm Cap Screw
Flat Washers
Handle _t
Use existing hardware
to attach left side of
support leg to unit
Nylon Washer / I
Wheel
Flat Washer
Axle /
20 mm Cap Screw _"_..
Leg E-Ring
Nut
O