Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION
STEP
2
Install
the
Header
Bracket
You can attach the header bracket either to the wall
above the garage door, or to the ceiling. Follow the
instructions which will work best for your particular
requirements.
Do not install the header bracket
over drywall.
If installing
into masonry,
use
concrete
anchors
(not provided).
WALL HEADER BRACKET INSTALLATION
• Center the bracket on the vertical centerline with
the bottom edge of the bracket on the horizontal
line as shown (with the arrow pointing toward the
ceiling).
• Mark the vertical set of bracket holes (do not use
the holes designated for ceiling mount). Drill 3/16"
pilot holes and fasten the bracket securely to a
structural support with the hardware provided.
Wall Mounting
Holes
Optional
Wall Mounting
Holes
Header
=
Wall
2x4
Structural
j
Support
The nail hole is for
You must use lag screws
to mount the header bracket.
Vertical
• Centerline
of
Garage Door
Lag Screws
5/16"x9x1-5/8"
HARDWARE
SHOWN ACTUAL
SIZE
J J I I I E E
Lag Screw
5/16"-9xl
-5/8"
/
f
/
Horizontal
Line
/
/
f
"l
j
Highest Point of
Garage Door Travel
Garage
= Door =
Centerline
of
Garage Door
CEILING HEADER BRACKET INSTALLATION
• Extend the vertical centerline onto the ceiling as
shown.
• Center the bracket on the vertical mark, no more
than 6" (15 cm) from the wall. Make sure the arrow
is pointing away from the wall. The bracket can be
mounted flush against the ceiling when clearance
is minimal.
• Mark the side holes. Drill 3/16" pilot holes and
fasten bracket securely to a structural support with
the hardware provided.
Ceiling Mounting
Holes
Door
_ _ _
- Finished
Ceiling
-
/ _ _
t / / _ / /
Vertical
_
/ _/_tIHeader
Centerline
_ _
Bracket
of Garage Door
6" (15 cm)
Maximum
-_1
Lag Screws
5/16"-9xl
-5/8"
The nail hole is for
positioning
only.
You must use lag screws
to mount the header bracket.
nf Qnr_a_
Dnnr
Header Wall
13
Publicidad
Capítulos
Tabla de contenido
