Publicidad
Idiomas disponibles
Idiomas disponibles
EN
IT IS THE RESPONSIBILITY OF THE EMPLOYER TO PLACE THE INFORMATION IN THIS MANUAL INTO THE HANDS OF THE OPERATOR.
PLACING TOOL IN SERVICE
• Always operate, inspect and maintain this tool in accordance
with all regulations (local, state, federal and country), that may
apply to hand held/hand operated pneumatic tools.
• For safety, top performance, and maximum durability of
parts, operate this tool at 90 psig (6.2 bar/620 kPa) maximum
supply hose.
• Always turn off the air supply and disconnect the air supply
hose before installing, removing or adjusting any accessory on
this tool, or before performing any maintenance on this tool.
• Do not use damaged, frayed or deteriorated air hoses and
tightly secured.
• Always use clean, dry air at 90 psig maximum air pressure.
Dust, corrosive fumes and/or excessive moisture can ruin the
motor of an air tool.
as kerosene, diesel or jet fuel.
• The use of a hose whip is recommended. A coupler connected
directly to the air inlet increases tool bulk and decreases tool
maneuverability.
• For maximum performance, the coupler on the wall should
be the next size larger than the coupler used on the tool. The
coupler closest to the tool should not be less than the proper air
supply hose size.
The use of other than genuine USAG replacement parts may result in safety hazards, decreased tool performance, and increased
maintenance, and may invalidate all warranties.
IMPORTANT SAFETY INFORMATION ENCLOSED.
READ THIS MANUAL BEFORE OPERATING TOOL.
FAILURE TO OBSERVE THE FOLLOWING WARNINGS COULD RESULT IN INJURY.
WARNING
USING THE TOOL
• Always wear eye protection when operating or performing
maintenance on this tool.
• Always wear hearing protection when operating this tool.
end of tool.
• Anticipate and be alert for sudden changes in motion during
start up and operation of any power tool.
the recommended air pressure.
• Air powered tools can vibrate in use. Vibration, repetitive
motions or uncomfortable positions may be harmful to your
hands and arms. Stop using any tool if discomfort, tingling fee-
ling or pain occurs. Seek medical advice before resuming use.
• Use accessories recommended by USAG.
• This tool is not designed for working in explosive atmosphe-
res.
• This tool is not insulated against electric shock.
NOTICE
Publicidad
