Safety Instructions For Power Lawnmower With Horizontally Rotating Blades; Before Starting The Engine - KLIPPO TRIUMPH Manual De Instrucciones

Models: Triumph, Champion, Excellent, Excellent GCV, Pro 17 GCV and Pro 19 GCV.
Engines: Briggs & Stratton; 550 Series, 625 Series, 675 Series. Honda; GCV 135.
Before starting, we recommend that you carefully read instruction manual in order to obtain the best from your mower.

Safety instructions for power lawnmower with horizontally rotating blades

These instructions are to be carfully studied before the lawnmower is used.
1. Keep hand and feet clear of the rotating blades and never
put your hand or foot into any ejector opening without fi rst
making sure that the blade is not moving and the ignition
cable is disconected from the spark plug.
2. Do not touch the blade until the ignition cable has been
disconected from the spark plug. Rotating the blades may
cause the engine to start.
3. Do not leave the machine unattended without stopping
the engine.
4. The engine speed regulator must not be disabled. The
pre-adjusted number of revolutions may not be changed.
Protections and safety devices may not be taken away or
be set out of function.
5. Do not top up with fuel when the engine is warm. Don´t
smoke while fi lling up with fuel or in the near of the tank.
WARNING! Petrol is very fl ammable! Store the fuel in
containers intended for petrol. Don´t remove the fuel fi ller
or fi ll up with fuel while the engine is running.
6. Never allow children or other persons whom are not
UPPER HANDLE
Fitted without tools, with a strong nut on the articulated plate.
HANDLE POSITION
When required, the handle can be rotated laterally to some
extent by means of the handle joint, e.g., when mowing close
to hedges or house walls. The handle can be set to different
positions for the best operating position. The handle can be
altered (not Triumph and Pro 17 GCV) in height at the chassis
mount by turning the nylon knobs (fi g. 1). On Triumph and Pro
17 GCV the heigth of the handle is changed by moving the
fastening screws of the under part of the handle to the other
hole nearby.
SETTING THE CUTTING HEIGHT (fi g. 2)
Move the lever forwards for taller grass. The lever positions
Before starting engines for the fi rst time: fi ll with oil (fi g 3.) and READ THE ENCLOSED INSTRUCTION MANUAL FOR THE ENGINE!
Unscrew the dipstick and fi ll up with approx. 0,55 lit. of engine
oil, viscosity SAE 30, Klippo oil no. 502873501 or accor-ding
to the engine manual. Fill up to the full graduation mark on the
dipstick (do not fi ll above it).
NB. THE OIL IS DRAINED PRIOR TO DELIVERY!
When operated for the fi rst time, the silencer will change
colour and may smoke briefl y.
OILCHECK
Check the oil level before starting and every fi ve hours. Take
off the dipstick and dry it up. Screw the dipstick into the tube
completely and make sure that the oil reaches the FULL mark
(fi g. 3).
Instruction manual for
KLIPPO LAWNMOWERS
Congratulations on purchasing a Klippo Lawnmower!
Fitting and adjustment

Before starting the engine

familiar with the machine to operate the lawnmower. Even
if the machine has very effective protections it could throw
out solid objects that can cause injurys.
7. Keep the lawn as clear as possible of stones or other
objects that the lawnmower can strike. Avoid driving over
gravel paths etc.
8. Famillarize lawnmower operators with the risks and ex-
plain how accident are to be avoided.
9. The machine may not be used for any other purpose than
cutting grass.
10. Wear pants and suitable shoes while cutting grass. Be
aware that a lawn could be slippery!
11. Never touch anything under the cutting deck, as for
instance dismount or mount the mulching insert, without
disconnecting the spark plug cable fi rst.
12. Do not use the lawnmower if any protection or safety
device is damaged. Inspect the machine before every use.
Control regularly that all screws and nuts are faste ned,
especially blade and engine.
correspond to 3-6 mm grass height. (2,5 - 5,5 cm on the
Triumph and 3,0-5,0 on the Pro 17 GCV).
All the weels are set simultaneously in one operation. Make
use of the effi cient height setting of the KLIPPO lawn-mowers
when mowing edges or trimming.
Never cut grass unnecessarily short. This makes spreading
more diffi cult and increases the risk of "scalping".
Discharge protection for Klippo Pro 4 SD, please look at the
enclosed assembly instruction.
Mulching insert Excellent-,Champion and Pro 19-models
This insert is mounted on the Excellent-models and is dis-
mounted on the Pro 19-models by delivery. This is mounted/
dismounted by the two screws on the rear/upper part of the
cutting deck (fi g. 11). Beware that the spark plug cable is discon-
nected before dismounting/mounting!
RUNNING-IN and FIRST OIL CHANGE
The engine has already been adjusted and require no run-
ning-in as such, although you should run it at no more than
moderate load for the fi rst few hours. Remeber to change the
oil the fi rst time after fi ve hours of operation (fi g. 9), and then
every twenty-fi ve hours.
PETROL
Use leadfree 95 octane petrol. Stop the engine before fi lling.
Do not overfi ll the tank so much that it overfl ows. Leave
around 6 mm for the fuel to expand.
Don´t let the machine stay over the winter with petrol in the
tank. This could cause starting problems in spring.
GB
17